ISO 18250-3 Figure C.2 Cross Port Reservoir Reference Connector

Role of the Figure C.2 Cross Port Reservoir Reference Connector in Testing

The ISO 18250-3 Figure C.2 Cross Port Reservoir Reference Connector is used as a defined reference component when configuring tests for cross port reservoir connectors. Its main role is to provide the reservoir-side reference interface required for checking the mating relationship between the customer’s connector sample and the selected ISO 18250-3 test setup.

Unlike reference connectors that are mainly identified by male or female mating direction, Figure C.2 is more closely related to the cross port reservoir connector structure itself. The correct use of this reference connector depends on the sample design, required ISO 18250-3 figure number and the related test configuration.

KINGPO supplies the Figure C.2 cross port reservoir reference connector as a precision-machined stainless steel component for ISO 18250-3 related laboratory verification. The complete test arrangement should be confirmed before quotation, especially when the connector is required together with other reference connectors, leakage equipment or mechanical fixtures.

What This ISO 18250-3 Figure C.2 Connector Is Used For

The Figure C.2 cross port reservoir reference connector is mainly used where the test setup requires a defined cross port reservoir reference interface. It helps laboratories and manufacturers configure the mating condition before carrying out the required connector performance evaluation.

Typical applications include:

• Cross port reservoir connector verification
• Enteral reservoir delivery system connector test setup
• Reference interface confirmation for ISO 18250-3 related testing
• Connector mating configuration review
• Product validation for reservoir connector designs
• Laboratory quality control and pre-compliance checking
• Configuration support for multi-connector ISO 18250-3 test projects

The exact test method and fixture arrangement should be confirmed according to the applicable ISO 18250-3 figure number, sample connector structure and selected test item.

Cross Port Reservoir Connector Test Setup Notes

Figure C.2 is normally selected as part of a complete connector test configuration rather than as a standalone measuring instrument. Before use, the sample connector structure and mating direction should be reviewed to confirm whether Figure C.2 is the correct reference component for the intended setup.

For projects involving several ISO 18250-3 reference connectors, Figure C.2 may need to be considered together with other connector figures depending on the test item. The fixture design, alignment method and connection condition should be reviewed before testing, because these factors may affect how the sample interfaces with the reference connector.

Before quotation, it is helpful to confirm:

• Required ISO 18250-3 figure number
• Sample connector structure
• Intended test item
• Whether Figure C.2 is required as a single component or part of a connector set
• Whether matching reference connectors are also required
• Whether leakage or mechanical test equipment is needed
• Documentation requirements for dimensional inspection or material information

Configuration and Documentation Notes

The Figure C.2 cross port reservoir reference connector is made from stainless steel and intended for repeated laboratory handling when properly used, cleaned and stored. Since ISO 18250-3 connector testing may involve different connector combinations and fixture arrangements, the reference connector should be selected together with the complete test requirement.

Documentation requirements can be discussed before order. Depending on the project scope, dimensional inspection records, material information or other supporting documents may be prepared according to the agreed supply requirements.